5182

		Model 5182 Current Preamplifier	Add to Quote Request

The model 5182 is a current-to-voltage preamplifier of low noise and low input impedance designed to amplify the extremely low currents encountered in such areas as photometry and semiconductor research. It has four standard sensitivity settings but in addition includes a special low-noise mode on the highest gain position for even better low current measurement capability. The unit features two outputs, allowing both the AC and DC components of the input signal to be independently monitored, so that, for example, in a PMT application the bias current can be measured separately from the signal current.

It can be powered from its own internally housed (alkaline) batteries, an external low voltage supply (±15 V or ±18 V) or from the model PS0108 remote line power supply(optional extra). This preamplifier can also be powered from most of our range of lockin amplifiers.

The model 5182 is ideally suited to amplifying signals from current sources such as electron multipliers, ion collectors, photomultipliers and photodiodes.

To view the Model 5182 Brochure (pdf) Click Here

		Model 5182 Current Preamplifier	Add to Quote Request

General
DC coupled current to voltage amplifier with adjustable sensitivity and a maximum frequency response extending from DC to 1 MHz. Single-ended virtual ground input and single-ended DC and AC coupled outputs via BNC connectors

Battery powered from internal alkaline batteries or external DC power supply.

Inputs
Modes	Single-ended virtual ground
Coupling	DC
Sensitivity	Switch selectable (5 settings)
AC Output	10^-5, 10⁸, 10⁷, 10⁸, 10⁸ low noise A/V
DC Output	10^-3, 10⁴, 10⁶, 10⁷, 10⁸ A/V
Accuracy	±2%
Stability	±300 ppm/* C
Impedance	see Figure 1
Max input w/o damage	±15 V DC or 10 V rms. AC @ 50 Hz
Noise	see Table 1
Frequency Response (AC Output)	lower limit 0.5 Hz upper limit depends on sensitivity setting, see Figure 2
Max DC current at input	see Table 1
Outputs
AC Output Impedance Max voltage swing Slow rate	450 Ω >10 V pk-pk > 22 V/µs
DC Output Impedance Max voltage swing Polarity	10 kΩ >±9 V Current flowing into the input produces positive output voltage
Power Internal	Four 9 V alkaline batteries provide approximately 15 hours of use
External a) b)	±15 V or ±18 V DC @ 25 mA 110 V AC or 240 V AC via optional external model PS0108 power supply
Dimensions (excluding connectors)	8.25" wide x 11" deep x 3.5" high (210 mm wide x 279 mm deep x 89 mm high)
Weight	5.3 lbs. (2.4 kg) excluding optional power supply