Reply Next Previous Up

Re: Time for Auto-sensitivity with Model 7220

From: Signal Recovery
email: info@signalrecovery.com
Model: 7220
Date: 03 Sep 2004

Comments

To check when an auto-sensitivity function has completed, use the command done bit in the serial poll status byte (GPIB) or wait for the prompt character (* or ?) when using RS232.


Last changed: April 01, 2008


SIGNAL RECOVERY is part of Advanced Measurement Technology, Inc, a division of AMETEK, Inc.
 It includes the businesses formerly trading as EG&G Instruments (Signal Recovery),
EG&G Signal Recovery and PerkinElmer Instruments (Signal Recovery)


Copyright© 2008 AMETEK, Inc.  Legal Notices

801 South Illinois Avenue, Oak Ridge, TN 37831-2011, U.S.A. (865) 482-4411 All Rights Reserved.

Ametek logois a trademark of AMETEK, Inc.